Delta VFD17AMS43AFSAA - Page 456

Chapter 12 Descriptions of Parameter SettingsMS300
447
Pr.
Parameter Name
Settings
07-19
Fan cooling control
2 (Fan is ON when the AC motor drive
runs; fan is OFF when the AC motor drive
stops)
 Setting 10: Logistics
The following table lists the relevant logistics setting application parameters.
Pr.
Parameter Name
Settings
00-20
Master frequency command source
(AUTO, REMOTE)
7 (Digital keypad potentiometer knob)
00-21
Operation command source
(AUTO, REMOTE)
1 (External terminals)
01-00
Motor 1 maximum operation frequency
Default setting
01-01
Rated / base frequency of motor 1
Default setting
01-02
Rated / base voltage of motor 1
400.0
01-04
Mid-point voltage 1 of motor 1
20.0
01-06
Mid-point voltage 2 of motor 1
20.0
01-08
Minimum output voltage of motor 1
20.0
01-03
Mid-point frequency 1 of motor 1
1.50
01-07
Minimum output frequency of motor 1
1.50
01-12
Acceleration time 1
3 (sec.)
01-13
Deceleration time 1
3 (sec.)
01-24
S-curve for acceleration begin time 1
0.00
01-25
S-curve for acceleration arrival time 2
0.00
01-26
S-curve for deceleration begin time 1
0.00
01-27
S-curve for deceleration arrival time 2
0.00
06-03
Over-current stall prevention during
acceleration
200
06-04
Over-current stall prevention during
operation
200
06-05
Acceleration / deceleration time selection
for stall prevention at constant speed
2: By the second acceleration / deceleration
time
07-23
Automatic voltage regulation (AVR)
function
1: Disable AVR
07-26
Torque compensation gain
0
 Setting 11: Tension PID
The following table lists the relevant tension PID setting application parameters.
Pr.
Parameter Name
Settings
00-20
Master frequency command source
(AUTO, REMOTE)
9 (PID controller)