Chapter 12 Descriptions of Parameter SettingsMS300
301
This function is valid when the source of the operation
command is the external terminal. ON: the drive executes
forward JOG. When executing the JOG command in torque
mode, the drive automatically switches to speed mode. The
drive returns to torque mode after the JOG command is
complete.
This function is valid when the source of the operation
command is the external terminal. ON: the drive executes
reverse JOG. When executing the JOG command in torque
mode, the drive automatically switches to speed mode. The
drive returns to torque mode after the JOG command is
complete.
ON: TQC mode, OFF: FOC mode.
ON: the speed is adjusted by the ASR 2 setting. OFF: the
speed is adjusted by the ASR 1 setting. Refer to Pr.11-02 for
details.
ON: the output of the drive stops immediately, displays “EF1”
on the keypad, and the motor is in free run status. The drive
keeps running until the external fault is cleared after you press
RESET on the keypad (EF: External Fault).