Page 36
FERTILIZER APPLICATOR CHECKLIST:
Downtime caused by eld breakdowns is costly and time consuming. Many breakdowns can
be eliminated by periodic equipment maintenance. By spending time reviewing this checklist
before seasonal fertilizer application time and following proper after season care, you can save
time and money later.
NOTE: DEMCO does not and will not make any
recommendations concerning application of various
chemicals or solutions. These recommendations
relate to either amount or procedure of materials
applied. If you have any questions regarding
application of certain chemicals or solutions, contact
your chemical supplier and follow chemical
manufacturer recommendations.
Check Before Going To The Field :
1. NOZZLES or KNIVES
Check tip or knife for excessive wear. Check nozzle
spacing by starting at center and working outwards.
Check that liquid comes out of each nozzle.
2. HOSES
Check all hoses for worn or soft spots. Be sure all hose
clamps are tightened and hoses are not kinked or pinched.
Check for leakage in any lines.
4. CONTROLS
Check for leakage, plugging, or wear on all valves, fittings,
etc. Clean off any build up of foreign material.
5. PUMP
Check to be sure pump turns freely.
6. FRAME
Be sure all bolts are tightened.
7. LUBRICATE MACHINE
Grease all zerks every 10 hours.
8. REPLACEMENT PARTS
Replace all worn or damaged parts.
After Season Care:
NOTE: It is important to wear proper safety equipment
when cleaning the applicator. See your
chemical or fertilizer package for this information.
1. After applying chemicals, run water mixed with cleaners
through tank, pump, filters, and all hose hookups.
2. When cleaned, tank should have all openings closed
or covered to keep dirt from entering.
3. Pump should be flushed with soluble oil and pump ports
plugged to keep out moisture and air.
4. Wash the machine using a pressure washer to remove
all debris to prevent corrosion.
5. Lubricate all grease zerks.
6. Dispose of all unused chemicals or solutions in a proper
and ecologically sound manner.
6. Water rinse and dry tips before storing.
• Keep hands, feet, and loose clothing away from rotating parts.
• Wear protective clothing recommended by your chemical and
fertilizer manufacturer when working with chemicals.
WARNING: To Prevent Serious Injury Or Death
4010 320th St., BOYDEN, IA. 51234
PH: (712) 725-2311
FAX: (712) 725-2380
TOLL FREE: 1-800-54DEMCO (1-800-543-3626)
www.demco-products.com
Go online to www.demco-products.com for Demco warranty
policies, operator manuals & product registration.
To Previous Page
Loading...
