To Next PageTo Next Page
Need help?Do you have a question about the Deming 5061 and is the answer not in the manual?
General| Brand | Deming |
|---|---|
| Model | 5061 |
| Category | Water Pump |
| Language | English |
Explains IMPORTANT!, CAUTION!, and WARNING! symbols used in the manual.
Covers electrical safety, operating hazards, and handling precautions.
Addresses safe product returns and material composition warnings.
Guidance on pump reception, storage conditions, and locating service centers.
Details on selecting pump location, preparing foundation, and leveling the unit.
Distinguishes factory alignment from field checks and preliminary alignment.
Step-by-step guide for aligning horizontal pump and driver shafts.
Explains methods for checking angular and parallel alignment using gauges.
Procedure for aligning vertical pump and driver shafts, including using dial indicators.
Instructions for preparing and applying grout for foundation stability.
Advice on suction and discharge piping size and friction loss.
Illustrates proper suction piping configurations to avoid air pockets.
Shows common errors in suction piping that can cause air pockets.
Guidelines for supporting pipes independently and using flexible connections.
Details on grease and oil lubricated bearings, including oiler installation.
Instructions for electrical wiring and checking pump rotation direction.
Methods for priming the pump, including by suction, ejector, or vacuum.
Checks required before starting and importance of discharge valve position.
Adjusting packing glands after starting to ensure proper lubrication.
Details on grease and oil lubrication for pump bearings.
Instructions for adjusting packing glands for proper lubrication and seal life.
Explanation of wearing rings, their function, and recommended clearances.
Procedure for complete disassembly of the pump, including bearing removal.
Detailed steps for assembling the pump, including impeller and bearing installation.
Common causes and checks for pumps not delivering liquid.
Troubleshooting steps for low flow or pressure issues.
Diagnosing problems like excessive power draw, vibration, or noise.
