11
TABLE OF CONTENTS
SECTION PAGE
A. INTRODUCTION 2
B. WARNINGS AND PRECAUTIONS 2-3
Emergency Termination of Laser Emissions
C. INDICATIONS FOR USE 3
D. FACILITY AND ENVIRONMENTAL
CONSIDERATIONS 3-4
Power requirements
Heating and Ventilation
Lighting
Combustible Chemicals and Gases
Plume Evacuation
Operatory Access during SOL Laser Use
E. GENERAL SAFETY 4
General Safety Considerations
Eye and Skin Protection
Table 1: NOHD (inches/cm)
Emergency Shutdown Options
F. INSTALLATION AND SETUP 5-6
Instructions on Unpacking &
Customer Service Assistance
Shipping Container Information
Contents of SOL Laser Shipping Container
Laser Hand Piece and Fiber
Fiber Wrap
Key Switch
AC/DC Power Supply Connector
Power On/Off Switch
Foot Switch Connector
Remote Interlock Connector
G. QUICK START INSTRUCTIONS 6
SOL Quick Start Instructions
SECTION PAGE
H. CONTROLS, OPERATION & USE 6-8
SOLSmart Presets
SOL Default Mode When the System is Turned On
SOL Presets
Ready (SOL Activation)
Pulse Mode
Beeping Volume
Aiming Beam
Emergency Stop
Remote Door Interlock
Battery Power
Operating Modes
Continuous Wave Mode
Tissue Response to Laser Energy
Installing and Replacing Single-Use Fiber Optic Tips
Initiating the Fiber
Cleaning Instructions
I. RECOMMENDATIONS FOR USE 8-10
Contraindications
Hard Tissue Procedures
Calibration
Single Use Tips For Infection Control
Checking Fiber Continuity
Test Firing the SOL Diode Laser
Using the SOL Diode Laser
J. DENMAT HOLDINGS, LLC SYSTEM
SPECIFICATION 10
Complies with
Hand Piece
Fiber Optic Tips
Accessories
K. SOL LASER SPECIFICATIONS 10
No Visible Light or Diffuse Light
Transmitted By The Aiming Beam
Replacing The Main Fiber
All Other Conditions
Send returns to
L. SOL SERVICE & TROUBLESHOOTING 10-12
No Visible Light – Aiming Beam
Replacing the Battery
Replacing the Fiber Optic Handpiece
All Other Conditions
Returns
M. SYSTEM WARRANTY 12-13
To Next Page
Loading...