16
FT & Super Six SP20001_REV_4
*HQHUDO/XEULFDWLRQ
'2*'5,9((YHU\'D\9(5<,03257$17
Apply a small squirt of lubricating oil (2-3 drops) directly into each hole in the top of the
drive shaft cover. This keeps the clutch slippers lubricated.
&21752//(9(56$1'&$%/(6(YHU\0RQWKV
To keep the controls free from rust and corrosion apply a small charge of oil to the
WKURWWOHDQGFOXWFKFRQWUROOHYHUVHYHU\WZRPRQWKV2LOÀRZFDQEHDVVLVWHGE\ZRUNLQJ
the levers open and closed a few times after the lubrication is applied.
)521752//(5$'-867(56(YHU\0RQWKV
Apply a small quantity of copper grease or similar to the adjuster studs to prevent corrosion and ease adjustment.
/XEULFDWH
'DLO\
6WRUDJH
The machine should always be kept in a clean dry place, free from condensation. After use ensure that the machine is
thoroughly clean, dry and free from grass and mud. Before off season storage smear a thin layer of grease on to the
cutter blades and the shear blade.
Under no circumstances must the machine be steam cleaned as this may remove grease from the pre packed bearings.
Because of the nature of lead free petrol we recomend that if the machine is being left unused for more than 2 weeks the
carburetor is run dry. Allow the engine to run out of fuel with the fuel tap switched off.
*XLGH7R5HSODFHPHQW3DUWV
WHEN ORDERING PARTS PLEASE QUOTE YOUR MACHINE SERIAL NUMBER AND
ENGINE NUMBER. A BOX TO ENTER THESE FOR EASY REFERENCE IS AT THE
BEGINNING OF THE MANUAL.
NOTE
This manual contains listing of parts for the Dennis FT430, FT510 and FT610 machines. An illustration of the parts as an
assembly is shown above the list.
Where parts are given a description of LH or RH (left hand or right hand) this is as viewed from the users position.
The Parts Listings for FT Range can be found in this manual from page 18 onwards.
To Next Page
Loading...
