ENGLISH
Getting Started Connections Playback Information Troubleshooting
NOTE
When a format other than the video format of the
connected monitor is set, the picture will not be
displayed properly. Use the procedure described
below to change the video format.
Operating from the Remote
Controller
GSet to NTSCH
• Press and hold the TOP MENU and PAGEu buttons for
at least 3 seconds.
“NTSC” is set.
GSet to PALH
• Press and hold the TOP MENU and PAGEi buttons for
at least 3 seconds.
“PAL” is set.
Always
30s
10s
[Selectable items]
NTSC
PAL
[Selectable items]
s Format
Select the video output signal format to
match the monitor.
d GUI time out
Set the GUI display time when not
operating.
b Normally there is no need to set this.
Setup
Other
Make various other settings.
Setup
Other
a iPod Charge
s Slide Show
d Interval
f Repeat
g Random
h Firmware Update
a iPod Charge
Set whether or not to charge the iPod on
the ASD-3W.
[Selectable items] ON
OFF
s Slide Show
Make slideshow settings.
[Selectable items] ON
OFF
GUI
Make GUI related settings.
Setup
GUI
a Screensaver
s Format
d GUI time out
[Selectable items] ON
OFF
a Screensaver
Make screensaver settings.
Use the screensaver to prevent burn-in on
the monitor screen.
When set to “ON”, the screensaver is
activated if there is no activity for about 3
minutes.
To Next Page
Loading...
