Denon AVC-A1H User Manual

Changing the strength of Tactile
Transducer according to the input
source (Tactile Transducer)
Adjusts the volume of the tactile transducer output.
1
Press OPTION.
An option menu screen is displayed.
0
When the input source is “HEOS Music”, an option menu for
online music is displayed. Select “AVR Options…”, then press
ENTER.
2
Use cursor Up/Down to select “Tactile Transducer”,
then press ENTER.
The “Tactile Transducer” screen is displayed.
3
Use cursor Left/Right to set the tactile transducer
function to on/off.
On
(Default):
Enable tactile Transducer.
Off: Disable tactile Transducer.
4
If you selected “On” in step 3, press cursor Down and
adjust the “Level”.
5
Use cursor Left/Right to adjust the tone, then press
ENTER.
-12.0 dB – +12.0 dB (Default : 0.0 dB)
0
“Tactile Transducer” settings are stored for each input source.
0
This cannot be set when the “Speakers” - “Manual Setup” - “Tactile Transducer
Setup” - “Tactile Transducer” is set to “Disabled”.
Contents Connections Playback Settings Tips Appendix
123
Front panel Display Rear panel Remote Index

Denon AVC-A1H Specifications

General

Channels	15.4
Power Output	150W per channel (8 ohms, 20Hz-20kHz, 0.05% 2ch Drive)
HDMI Outputs	3
Audio Formats	Dolby Atmos, DTS:X, Auro-3D, IMAX Enhanced
Wireless Connectivity	Wi-Fi, Bluetooth
Type	AV Amplifier
IMAX Enhanced	Yes
8K/60Hz Pass-through	Yes
4K/120Hz Pass-through	Yes
HDR Support	HDR10, HDR10+, Dolby Vision, HLG
eARC	Yes
Phono Input	Yes
THD	0.05%
Frequency Response	10 Hz - 100 kHz
Input Sensitivity	200 mV
Signal-to-Noise Ratio	102 dB
Ethernet	Yes
USB Port	Yes
Multi-Room Audio	HEOS
Amplifier Type	Class AB