EasyManuals Logo

Denon AVR-S740H User Manual

Denon AVR-S740H
272 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #213 background imageLoading...
Page #213 background image
DTS sound is not output.
0
Check that the digital audio output setting on the connected device is set to “DTS”.
Dolby Atmos, Dolby TrueHD, DTS-HD, Dolby Digital Plus audio is not output.
0
Make HDMI connections. (v p. 52)
0
Check the digital audio output setting on the connected device. On some devices, “PCM” is set by default.
DTS Neural:X mode cannot be selected.
0
DTS Neural:X cannot be selected when using the headphones.
Dolby Surround mode cannot be selected.
0
Dolby Surround cannot be selected when using the headphones.
Audyssey MultEQ
®
, Audyssey Dynamic EQ
®
and Audyssey Dynamic Volume
®
cannot be selected.
0
These cannot be selected when you have not performed Audyssey
®
Setup. (v p. 166)
0
Switch to a sound mode other than “Direct”. (v p. 109)
0
These cannot be selected when sound mode is “DTS Virtual:X” or sound mode that have “+Virtual:X” in the sound mode name.
0
These cannot be selected when using the headphones.
“Restorer” cannot be selected.
0
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of multichannel signals such as Dolby Digital or DTS
surround, “Restorer” cannot be used. (v p. 145)
0
Switch to a sound mode other than “Direct”. (v
p. 109)
No sound is output when using ZONE2.
0
Digital signal audio input from the HDMI connector or digital audio connectors (OPTICAL/COAXIAL) cannot be played back. Use analog connections.
0
When listening to audio from a Bluetooth device in ZONE2, remove any obstructions between the Bluetooth device and this unit and use it within a
range of about 98.4 ft/30 m.
Contents
Connections Playback Settings Tips Appendix
213
Front panel Display Rear panel Remote Index

Other manuals for Denon AVR-S740H

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-S740H and is the answer not in the manual?

Denon AVR-S740H Specifications

General IconGeneral
Channels7.2
Power Output per Channel75 W (8 Ohms, 20 Hz - 20 kHz, 0.08% THD)
HDMI Inputs6
HDMI Outputs1
Dolby AtmosYes
DTS:XYes
BluetoothYes
Wi-FiYes
HEOS Multi-roomYes
4K Ultra HD Pass-throughYes
Power Output per Channel (6 Ohms)110 W (6 Ohms, 1 kHz, 0.7% THD)
4K/Ultra HD UpscalingYes
Phono InputYes
Dolby SupportDolby Atmos, Dolby TrueHD, Dolby Surround
Auto CalibrationAudyssey MultEQ
Input Sensitivity/Impedance200 mV / 47 kOhms
Signal-to-Noise Ratio98 dB (IHF-A weighted, Direct mode)
EthernetYes
USB PortYes (front)
AM/FM TunerYes
Supported Audio FormatsMP3, WMA, AAC, FLAC, ALAC, WAV, DSD
HDR SupportHDR10, HLG, Dolby Vision
Wireless AudioAirPlay 2
DTS SupportDTS:X, DTS-HD Master Audio
Zone AudioZone 2
Frequency Response10 Hz - 100 kHz (+1, -3 dB, Direct Mode)
Total Harmonic Distortion0.08% (20 Hz - 20 kHz)
Built-in DAC192 kHz / 24-bit

Related product manuals