EasyManuals Logo

Denon AVR-X2500H Service Manual

Denon AVR-X2500H
173 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #120 background imageLoading...
Page #120 background image
Example
The rst eight bytes are normally
"00FFFFFFFFFFFF00".
*If the AVR and the TV are not con-
nected via HDMI, the correct register
value cannot be veried.
When the results of check item (65) are "03"
(Detection of HPD is OK / Detection of RXSENSE is OK )
Check item(66). Check the Monitor EDID :
① Unplug the AC cord. Plug the AC cord into a power outlet.
Send the transmission command "m_2" from Termite.exe.
Are the rst eight bytes of the returned value "00FFFFFFFFFFFF00"?
Check item(67). Checking the TMDS :
Check the TMDS waveform at the following test
point.
N1030
D2+
D2-
D1+
D1-
D0+
D0-
CK+
CK-
HDMI
OUT 2
HDMI
OUT 2
Check item(68). Check communication with the
monitor :
Are waveforms of "DDCCLK" and "DDCSDA"
observed at the test point near the HDMI output
terminal [N1030]?
N1030
DDCSCK
DDCSDA
HDMI
OUT 2
HDMI
OUT 2
Checking the EDID register. (Monitor2)
HDMI Tx [U1039] is faulty.
Replace with a new device.
Recheck from check item (3).
If it does not work, replace the PCB.
HDMI Tx [U1039] is faulty.
Replace with a new device.
Check for a short circuit in the TMDS line.
If there is no problem, the HDMI Tx
[U1039] is faulty.
Replace with a new device.
HDMI Tx [U1039] is faulty.
Replace with a new device.
NOYES NOYES
less than 100KHz
5V
5V
This diagram shows an example of the DDC communica-
tion waveform.
-The high level voltage is 5V.
-The frequency of the DDC CLK is 100 KHz or less.
Check at each test point.
Voltage scale:2.0V/div
Time scale:40us/div
YES NO
Before Servicing
This Unit
Electrical Mechanical Repair Information Updating
120

Other manuals for Denon AVR-X2500H

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-X2500H and is the answer not in the manual?

Denon AVR-X2500H Specifications

General IconGeneral
HDMI in8
Composite video in2
Ethernet LAN (RJ-45) ports1
AirPlayNo
Display-
Sample rate196 kHz
HDCP version2.2
Product colorBlack
Audio decodersDSD, DTS-HD, DTS:X, Dolby Atmos, Dolby Surround, Dolby TrueHD
Volume controlRotary
RS-232 interfaceYes
Connectivity technologyWired & Wireless
Receiver typeSurround
Frequency range20 - 20000 Hz
Output impedance8 Ω
Input sensitivity200 mV
Audio output channels7.1 channels
Signal-to-Noise Ratio (SNR)100 dB
Total Harmonic Distortion (THD)0.08 %
Power output per channel (1KHz@6 Ohm)185 W
Power output per channel (20-20KHz@8 Ohm)95 W
AC input voltage230 V
AC input frequency50 Hz
Power consumption (standby)0.5 W
Power consumption (typical)500 W
Audio formats supportedAAC, ALAC, DSD, FLAC, MP3, WAV, WMA
AM band range520 - 1611 kHz
FM band range87.5 - 108 MHz
Supported radio bandsAM, FM
Internet radio services supportedDeezer, Napster, Pandora, SIRIUS Internet Radio, Spotify, Tidal, TuneIn, iHeartRadio
Supported graphics resolutions3840 x 2160
Weight and Dimensions IconWeight and Dimensions
Depth340.3 mm
Width434.3 mm
Height167.6 mm
Weight9389 g

Related product manuals