Sound mode type Description
IMAX DTS
This mode is automatically activated when playing back IMAX Enhanced content featuring a DTS bitstream. (v p. 173)
0
Also this mode is selectable when “Surround Parameter” - “IMAX” is set to “On” in the menu and a 48 kHz sampling
frequency DTS 5.1 channel signal is being input.
0
When “Speaker Config.” - “Surr. Back” is set to “2 spkrs”, “Speaker Config.” - “Center” is set to “Large” or “Small”, and
sound mode is set to “IMAX DTS”, surround audio is output from the surround back speaker. Audio is not output from
the surround speaker.
0
The bass information of speakers are not redirected to the subwoofer, but getting a better bass effect from front and
center speakers by special algorithm of IMAX when the “Front” and “Center” are set to “Small”.
IMAX DTS:X This mode is automatically activated when playing back IMAX Enhanced content featuring a DTS:X bitstream.
(v p. 173)
0
The bass information of speakers are not redirected to the subwoofer, but getting a better bass effect from front and
center speakers by special algorithm of IMAX when the “Front” and “Center” are set to “Small”.
DTS Neural:X This mode uses DTS Neural:X Upmixer to extend various sources to natural and realistic multi channels for playback.
Use height speakers such as front height speakers to realize a three-dimensional sound field.
DTS Virtual:X
z
2
z
3
This mode uses DTS Virtual:X with virtual height and virtual surround processing to realize a three-dimensional sound field
when the height speakers are not used.
z1 This can be selected when “Speaker Config.” - “Surr. Back” is not set to “None”. (v p. 223)
z2
It cannot be selected when the input signal is Dolby Digital, Dolby Digital Plus, Dolby TrueHD or Dolby Atmos.
z3
This can be selected when Height, Ceiling and Dolby Atmos Enabled speakers are not being used.
Contents
Connections Playback Settings Tips Appendix
138
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
