Name: Denon AVR-X3700H
Brand: Denon
Rating: 4 (1 reviews)

To Next Page

To Previous Page

HDCP Setup

Sets the HDCP version for each HDMI input source.

Video may not be output depending on the HDCP version of your player

and the TV.

If this issue occurs, use this setting to set one version of HDCP. This may

be able to output video.

Auto

(Default):

Automatically applies the HDCP version of

this unit according to TV.

1.4: Fixes the HDCP version of this unit to 1.4.

2.3: Fixes the HDCP version of this unit to 2.3.

“Custom” is displayed for the setting item if our service engineers or custom

installers has configured the HDCP version for this unit.

TV Format

Set the video signal format to be output for the TV you are using.

Format

NTSC

(Default):

Select NTSC output.

PAL: Select PAL output.

“Format” can also be set by the following procedure. However, the menu

screen is not displayed. Following the display content to make the setting.

1. Press and hold the main unit’s ZONE2 SOURCE and STATUS at the same

time for at least 3 seconds.

“V.Format:<NTSC>” appears on the display.

2. Use the main unit’s TUNER PRESET CH + or TUNER PRESET CH – and

set the video signal format.

3. Press the main unit’s STATUS to complete the setting.

NOTE

When a format other than the video format of the connected TV is set, the

picture will not be displayed properly.

Contents Connections Playback Settings Tips Appendix

199

Front panel Display Rear panel Remote Index

Other manuals for Denon AVR-X3700H

Questions and Answers:

Need help?

Do you have a question about the Denon AVR-X3700H and is the answer not in the manual?

General