Name: Denon AVR-X3700H
Brand: Denon
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Network

To use this unit by connecting it to a home network (LAN), you must configure network settings.

If you set up your home network (LAN) via DHCP, set “DHCP” to “On”. (Use the default setting.) This allows this unit to use your home network (LAN).

When assigning an IP address to each device manually, you need to assign an IP address to this unit using the “IP Address” settings, and enter

information about your home network (LAN) such as the gateway address and subnet mask, etc.

Information

Display network information.

Friendly Name / Connection / SSID / DHCP / IP Address /

MAC Address (Ethernet) / MAC Address (Wi-Fi) /

Wi-Fi signal strength

Connection

Choose whether to connect the home network to a wireless LAN or a

wired LAN.

When connecting to the network using wired LAN, select “Wired

(Ethernet)” after connecting a LAN cable.

When connecting to the network using wireless LAN, select “Wireless (Wi-

Fi)” and configure the “Wi-Fi Setup”. (v p. 232)

Connect Using

Select the method for connecting to the home network (LAN).

Wired (Ethernet): Use a LAN cable to connect to a network.

Wireless (Wi-Fi)

(Default):

Use the wireless LAN (Wi-Fi) function to

connect to a network.

Contents Connections Playback Settings Tips Appendix

231

Front panel Display Rear panel Remote Index

Other manuals for Denon AVR-X3700H

Questions and Answers:

Need help?

Do you have a question about the Denon AVR-X3700H and is the answer not in the manual?

General