Denon AVR-X6800H - Page 226

Manual Setup
Perform when setting the speakers manually or when changing settings
made in Audyssey
®
Setup.
0
If you enable new speakers in the speaker configuration menu after
performing Audyssey
®
Setup, you will no longer be able to select
Audyssey MultEQ
®
XT32, Audyssey Dynamic EQ
®
or Audyssey
Dynamic Volume
®
. (v p. 195)
0
Changing the following settings:
Distances / Levels / Crossovers settings will not disable Audyssey
®
or
require running Audyssey
®
Setup again.
0
“Manual Setup” can be used without changing the settings. Please set if
necessary.
Speaker Layout
Select a suitable speaker layout for your speaker system.
o
Amp Assign
Select the power amplifier usage method to match your speaker
system.
You need to configure the detailed settings for the speaker
configuration in accordance with the selected mode. Select Amp
Assign configure the corresponding detailed settings.
13.1ch:
0
Setting to use the 11-channel power
amplifier in this unit and an external
power amplifier connected to PRE OUT
to play back up to 13.1-channels.
0
You can connect speakers for up to 11.1-
channels for MAIN ZONE.
11.1ch:
0
Settings to assign all power amplifier
within this unit to MAIN ZONE to play
back up to 11.1-channels.
9.1ch + ZONE2
(Default):
0
Setting to assign the power amplifiers in
this unit for ZONE2 to 2-channels.
0
You can connect speakers for up to 9.1-
channels for MAIN ZONE.
Contents Connections Playback Settings Tips Appendix
226
Front panel Display Rear panel Remote Index