9
Network connections
Using PC to make network settings of this unit
Before turning this unit on, make sure that no Ethernet cable is connected to this unit. If a cable is
connected, unplug this unit’s power cord, then disconnect the cable.
1
Press X to turn on power to the main unit.
It takes approximately 30 seconds for this unit to start.
2
Press NETLINK on the rear panel for 3 seconds.
This unit restarts and “Reboot in NetLink mode” appears on the display.
3
Connect to “Cocoon_Setup zzzzzz” in the wireless network settings on your
PC. (zzzzzz is the MAC address)
•If “Cocoon_Setup zzzzzz” is not displayed, refresh the network.
•It may take up to two minutes to establish the connection.
4
Launch the browser on the PC connected to this unit, and enter the address
“http://169.254.1.1”.
5
On the page that appears, set the information necessary for the network connection.
q Click “Profile Configuration” on the upper left part of the page.
w Select the SSID to be used.
e Click “ADVANCE SETTING”.
r Enter required items.
t When settings are completed, click “Apply”.
•“Connecting” is displayed, and the unit starts connecting to the LAN.
•When the connection is made successfully, “Connected!” appears.
•If the connection cannot be established, “Connection Failed” is displayed. If this should happen, unplug
this unit’s power cord, then plug it back in and repeat the operation from step 1 to step 5.
q
e
r
t
w
To Next Page
Loading...
