Denon DCD-600NE - Switching the Pure Direct mode

Switching the display’s brightness
The display brightness can be adjusted between four levels. Switching the
display off reduces a source of noise that affects sound quality, enabling
higher sound quality playback.
1
Press DIMMER.
0
The brightness of the display switches each time the button is
pressed.
0
The display brightness is set to most brightly by default.
0
Press and hold DIMMER for more than 2 seconds to return the display brightness
to the default setting.
Switching the Pure Direct mode
In Pure Direct mode, the display turns off and digital audio output stops.
This reduces the source of noise that can adversely affect sound quality,
enabling high quality playback.
1
Press PURE DIRECT.
The display turned off, and Pure Direct playback begins.
0
Switches the Pure Direct mode each time the button is pressed.
PURE DIRECT ON
MODE1:
Turns off the display and outputs digital
audio.
PURE DIRECT ON
MODE2:
Turns off the display and stops output of
digital audio.
PURE DIRECT OFF
(Default):
Disables Pure Direct mode.
0
The display brightness cannot be changed in Pure Direct mode.
0
The display is only turned off during playback.
Contents Connections Playback Settings Tips Appendix
24
Front panel Display Rear panel Remote Index