Denon DHT-S716H - Page 46

The following transition occurs during connection to the network. Refer to "QSG".
Not connected
Press "Connect" but-
ton.
Connection estab-
lished between HEOS
and smartphone
Connected to the
network
When network
connection setup is
complete
Amber : SolidGreen : BlinkingGreen : SolidBlue : BlinkingBlue : Solid
Time-out
Red : Solid (7sec.)
The following transition occurs when the "
Bluetooth
" button is pressed.
Bluetooth Pairing enabledPairing successful
Green : Blinking Twice
Repeated
Blue : Blinking Once
Repeated
Pairing failed
Red : Solid (7sec.)
8. When connecting to network (Setup Assistant)
9. Bluetooth
The following transition occurs when this unit switches to standby.
Network con-
nected
Quick Start mode
No access over
20 min.
Blue : Solid
Blue : Solid
(Dimmer)
Access from app
Not connectedNot connectedDeep Standby
No access over
20 min.
60 min. later.
Amber : SolidAmber : SolidLED : Off
Access from appButton operation
Connected to the
network
The indicators are lit as shown below when the "
Volume
" button and "
Mute
" button are pressed.
"Volume" button"Mute" button
Blue : Fast BlinkingBlue : Solid
The following transition occurs when "Submit Diagnostics" is performed from the HEOS app.
Operations in HEOS app : Settings - Advanced - Submit Diagnostics
Network connectedSending diagnostic dataDiagnostic data sent
Blue : SolidPurple : BlinkingBlue : Solid
Time out in HEOS app
Red : Blinking Once
10. Standby
11. Volume button and Mute button
12. Submit Diagnostics
Status LED Connect in Status LED
46
Caution in
servicing
Electrical Mechanical Repair Information Updating