Denon DP-37F User Manual

MAKE
THE
FOLLOWING
ADJUSTMENT
WITH
THE
POWER
TURNED
OFF.
4. Release the arm clamp
Hold
the
tonearm
and
lower
the
arm
clamp
in
the direction of the arrow.
\
Armrest
Arm clamp
2. Move the tonearm
Take
the
tonearm
off
the
arm
rest
and
move
it
to.a
position
between
the
arm
rest
and
the
turn-
table.
Damping adjustment
knob
Tracking force/anti-skating
adjustment knob
Armrest
3. Balance the tonearm horizontally
Rotate
the
counter
weight
knob
until
the
tone-
arm
remains
balanced
parallel
to
the
turntable
surface.
Counter weight knob
Make parallel
Rotate
the
counter
weight
knob
in
the
direction
of
the
arrow.
4. Return the tonearm to the arm rest
Return
the
tonearm
to
the
arm
rest
and
hold
it
in place with the clamp.
Arm clamp
7
5.
Adjust
the
tracking
force
and
the
anti-skating
Since
the
cartridge
supplied
with
this
turntable
requires
a
stylus
force
of
1.8
g,
rotate
the
stylus
force
knob
and
align
the
number
1.8
with
the
reference
line.
The
anti-skating
is
automatically
adjusted
at
the
same
time.
TRACKING FORCE |
ANTI-SKATING '
Reference line
WHEN
ADJUSTING
THE
TRACKING
FORCE
AND
THE
ANTI-SKATING
When
using
a
cartridge
other
than
the
one
supplied
with
this
turntable,
apply
the
suitable
stylus
force
for
it
after
consulting
the
cartridge
instruction
manual.
The
anti-skating
is
automatically
adjusted
at
the
same
time.
Since
the
cartridge
supplied
with
this
turntable
requires
a
O-damping
value
of
1.8,
rotate
of
1.8,
rotate
the
Q-damping
knob
and
align
the
number
1.8
with
the
reference
line.
@
Although
the
optimum
Q-damping
value
varies
according
to
the
cartridge
compliance,
this
turntable
is
so
designed
that
the
optimum
amount
of
damping
can
be
obtained
by
setting
the
knob
to
the
same
value
as
that
for
the
tracking
force.
Q DAMPING Reference line

Denon DP-37F Specifications

General

Drive System	Direct Drive
Signal to Noise Ratio	78 dB
Speed	33 1/3, 45rpm
Cartridge weight	4 to 10g
Output Voltage	2.5 mV (1 kHz, 5 cm/sec)
Frequency Response	20 Hz - 20 kHz
Turntable Platter	300 mm, Aluminum Diecast