To Next PageTo Next Page
Need help?Do you have a question about the Denon DP-45F and is the answer not in the manual?
General| Drive System | Direct Drive |
|---|---|
| Motor | DC Servo Motor |
| Overhang | 15 mm |
| Output Voltage | 2.5 mV |
| Power Supply | AC 120V, 60Hz |
| Speed | 33 1/3, 45 RPM |
| Type | Direct Drive Turntable |
| Speeds | 33 1/3, 45 RPM |
| Tonearm | S-shaped Tonearm |
| Cartridge Weight | 4 - 10 g |
| Stylus | Diamond |
| Platter | Aluminum |
| Motor Type | DC Servo Motor |
| Tonearm Type | Static Balance |
Describes the advanced tonearm system for automatic operation and sound quality.
Explains electronic damping of low-frequency resonance for improved sound.
Details the straight tonearm's tracing ability for high-compliance cartridges.
Introduces the feature allowing manual tonearm positioning for playback start.
Explains automatic detection of record size and speed selection for plays.
Highlights the quartz lock and bi-directional servo for rotational accuracy.
Describes the DL-60 cartridge and its elliptical stylus for clarity.
Instructions for removing protective packaging from the unit.
Steps for setting up the platter and mat, including alignment notes.
Guidance on connecting audio output wires to the amplifier's PHONO input.
Instructions for connecting the unit to a power source.
Step to unlock the tonearm before adjustments.
Guide on positioning the tonearm for balancing.
How to balance the tonearm using the counter weight.
Returning the tonearm to its resting position after balancing.
Detailed steps for setting stylus force and automatic anti-skating.
How to set the Q-damping value for optimal performance.
Initial setup steps before starting playback on the DP-35F.
Guide for operating the turntable in automatic playback mode.
Instructions for manual record playback, including special methods.
Initial setup steps before starting playback on the DP-45F.
Guide for operating the DP-45F in automatic playback mode.
Instructions for manual record playback on the DP-45F.
How to use the "locate" function for precise playback starting points.
Special procedure for playing transparent records.
How to stop playback, either fully or by lifting the tonearm.
Steps and advice for replacing the stylus, including recommended types.
Guidance on replacing the cartridge, wiring, and overhang adjustment.
Solutions for when the turntable fails to start or the tonearm doesn't move.
Troubleshooting steps for when there is no audio output.
How to resolve audible humming or buzzing noises.
Causes and solutions for the stylus skipping on the record.
What to do if the tonearm movement stops unexpectedly during playback.
Tips for adjusting audio levels that are too low or too high.
How to prevent tuner interference from the turntable operation.
Explains that tonearm movement on power-up is normal operation.
Reasons why the tonearm might return prematurely to the arm rest.
Addresses incorrect tonearm positioning for different record sizes.
Troubleshooting issues with automatic record size detection.
Specific issue where tonearm returns on starting 17cm records.
Technical details of the turntable's motor system, speeds, and control.
Specifications for the turntable platter and motor type.
Details on the speed control system and its characteristics.
Technical specifications for the tonearm, including type, length, and overhang.
Information on the automatic system's control and adjustments.
Specifications for the included DL-60 cartridge, including output and frequency response.
General power supply, consumption, dimensions, and weight specifications.
