Denon HEOS 7 HS2 - Power Management Options; HEOS Power Modes Explained

Power management
Power modes
o
Quick Start Mode
HEOS device automatically enters "Quick Start Mode" to save power
in the following cases. This unit will automatically resume to full power
whenever the device is selected and playing music.
The status LED dims when the mode is switched to Quick Start Mode.
n
Ethernet
After around 20 minutes of no operation and no network access after
playing music via Ethernet.
n
Wi-Fi
After around 20 minutes of no operation and no network access after
playing music via Wi-Fi.
n
USB
After around 20 minutes of no operation and no network access after
playing music from a USB memory device.
n
Bluetooth
After the Bluetooth connection is disconnected and there is around 20
minutes of no operation and no network access after playing music via
Bluetooth.
n
AUX IN
After around 20 minutes of no operation after AUX cable is
disconnected.
o
Deep Standby
The device also has the ability to automatically enter “Deep Standby”
whenever the wired or wireless network connection is removed for
more than 60 minutes in "Quick Start Mode". The front panel LED will
turn off during Deep Standby.
To “wake” a HEOS device from Deep Standby, you must press the
volume or mute buttons which will immediately turn on the front panel
LED.
0
You also push the mute button for 3 seconds, the device enters the Deep
Standby.
o
Off
To completely turn off the power to the device you must remove the
mains plug from the power outlet.
Contents
Setup Use Troubleshooting Status LED Appendix
45