Denon PMA-500AE - Page 13

NOTE FOR PARTS LIST
Part indicated with the mark "nsp" are not always in stock and possibly to
take a long period of time for supplying, or in some case supplying of part
may be refused.
When ordering of part, clearly indicate "1" and "I" (i) to avoid mis-
supplying.
Ordering part without stating its part number can not be supplied.
Part indicated with the mark " %& " is not illustrated in the exploded view.
Not including General-purpose Carbon Film Resistor in the P.W.Board
parts list. (Refer to the Schematic Diagram for those parts.)
Not including General-purpose Carbon Chip Resistor in the P.W.Board
parts list. (Refer to the Schematic Diagram for those parts.)
WARNING:
Parts marked with this symbol /\ have critical characteristics.
Use ONLY replacement parts recommended by the manufacturer.
@ Resistors
Ex: BN 14K 2E 182 G ER
Type Shape Power Resist- Allowable Others
and per- ance error
| formance | | |
: Carbon : Pulse-resistant type
> : Composition : Low noise type
: Metal oxide film : Non-burning type
+ Winding : Fuse-resistor
: Lead wire forming : Metal film
: Metal mixture
+ Resistance
18 =» 1800 ohm = 1.8 kohm
indicates number of zeros after effective number.
2-digit effective number.
«Units: ohm
1A 2 = =) 1.20hm
t + 1 -digit effective number.
2-digit effective number, decimal point indicated by R.
« Units: ohm
@ Capacitors
Ex. CE 04W dH 2R2 M BP
Type Shape Dielectric Capacity Allowable Others
and per- strength
formance
error
CE: Aluminum toil : High stability type
electrolytic
CA : Aluminum solid : Non-polar type
electrolytic
CS : Tantalum electrolytic : Ripple-resistant type
CQ . Film : For change and discharge
CK : Ceramic : For assuring high
sequency
CC : Ceramic UL part
CP : Oil : CSApart
CM | Mica : UL-CSA type
OF : Metallized 2c - 160V Lead wire forming
CH : Metallized 2D : 200V
2E : 250V
2H : 500V
23: 630V
2.2 2 => 2200uF
i 4 Indicates number of zeros after effective number.
2-digit effective number.
* Units: LF.
2.R 2 = 2.2uF
t 1-digit effective number.
2-digit effective number, decimal point indicated by R.
© Units: pF.
** Capacity (except electrolyte)
2.2 2 => 2200pF=0.0022uF
t. (More than 2}- indicates number of zeros after effective number.
2-digit effective number.
* Units: pF.
2 1 = 220pF
& (ort)
« Uniis: pF.
indicates number of zeros after effective number.
2-digit effective number.
* When the dielectric strength is indicated in AC, "AC" is included after the dieelectric
strength value.
PMA-500AE
oR mazrela Dl T
. nsp ORB BAERLTORCAD CHBICRRAZETSOCe
DHVEF.
Balko Ts, ARZEMUTSTCOHBVET.
2. BREET SIRICMED" 1" ERED" |" EDK E
YECA LTC HEN
3. BRBESZRARL TUB Mmlis He CEE HAL
4. APMORESRELBESBACT. SAT SLEd, REBKUE
BEMEEO Te OKT TEO Bane CAS TEE.
KMOOWTWS Paald TEI Hic leads L TOE TA.
ARA—AKVMBSERL THE CA. ERI RM SRE
T.
ARA-KY Fy THnsslssceR lL THECA, EMIS ARRe SR
FOES.
BmROMie. IVT VU ORES OMAR eESRLT <HE
2 OL AB
ARES Bett
SRR
BRiRe
: US RAE
* PRIA
>
envsy yt
BI) CE aw LHR? MBP
FM HARAE RTE
c
CE: FIVS Tee v
CA: VS ARB Vv
CS : Fu FIBRE a Vv
v
v
MRE E
SORTER
Ey FOE
cQ : Fabs IE: 25 DL: FER
CK st Bee oe IV: 38 HF : ie Fwe ORG AL
CC RSS oF JH :50 V Uo: UL aba
ceo: Ftv 2A + 100-V¥ Co: CSA Abad
VA
RIGIAE
RVSIRE
CM :
GE:
CH y
Po: +100%
-— O%
Co: 40.25pr
1D: +0.5pF
SOM
Wo: OUL-CSA &haa
2B: 128 V
¢ Foo; Um FR ati
2C : 10 V
2D : 200 ¥
2E + 250 V
: S00 V
> 630 V
: Bare
@ BHI FL SUORS
& — 2200pF=0.0022uF
<< OORARNT,
: Bape
ey
@MEZRMCRTAT SRR, MEATOKE (ac) HRLET.
13