Denon PMA-500V - Page 8

races asi eB ik RS DIRT TRY RAN
Siethcnintnai meth
@ Monitoring the Recording
A recording in progress can be monitored if
a tape deck with three individual heads for
recording and playback is used. A tape deck
in which a common head is used for both
recording and playback cannot be used to
monitor recording. Set the MONITOR/
COPY knob to Tape-1 or Tape-2 to cor-
respond to the tape deck that is being used
for the recording. Use the TAPE MONITOR
switch to switch between the recording
monitor and the program source.
@ Using the Amp with a Graphic Equalizer
@ Remove the jumper pin from the
PROCESSOR LOOP. terminal. (The power
switch should be turned OFF.)
@ Operate the graphic equalizer (which
should be connected to set it in ready
state, (For details, refer to the operating
manual for the graphic equalizer.)
@® If the graphic equalizer has an output level
knob (OUTPUT LEVEL), adjust it to-
gether with the volume adjustment knob
on the amp (VOLUME) and set it in a
position that produces a suitable volume.
@ Use the volume, balance and tone knobs to
set a suitable volume and adjust the quality
of the sound.
Set to Tape-1 when the tape deck is
connected to TAPE-1, and Tape-2 when
the tape deck is connected to TAPE-2.
[HRI HHH
Graphic Equalizer
—3—