Connecting by using the WPS
button on the router
If you are using a wireless router that supports WPS (Wi-Fi Protected
Setup™), connect to the network with the "push button method". (Wi-Fi
Protected Setup™ is trademarks of Wi-Fi Alliance.)
1
Press the WPS button on your router.
2
Within 2 minutes, press and hold the CONNECT button
on the remote control for 5 seconds.
“WPS Connecting” is shown on the display and the connection is
started.
0
When connected, “WPS Connected” is shown on the display.
Contents Connections Playback Settings Tips Appendix
70
Front panel Rear panel
Remote control
unit
Index
To Next Page
Loading...
