4
Setup
Important: Occasionally, we may update SC6000 PRIME’s firmware to add exciting new features and
improvements. Visit denondj.com to check for available firmware updates, especially after you update your
software (firmware updates may address new software features).
1. Visit denondj.com and log into your account. (Create an account if this is your first Denon DJ product.)
2. In your account, download and install the latest version of Engine Prime. Double-click the .exe (Windows
®
) or
.dmg (macOS
®
) installer file you downloaded, and then follow the on-screen instructions to install Engine
Prime.
3. Make sure all of your devices are powered off or all of their volume levels are at their minimum positions.
4. Connect SC6000 PRIME’s audio outputs (Layer A/B or Digital Outputs A/B) to the inputs of your mixer.
5. Connect SC6000 PRIME’s Link ports according to one of the following connection diagram examples.
6. Connect any output devices (headphones, power amplifiers, loudspeakers, etc.) to the outputs of your mixer.
7. Connect all of your devices to power sources.
• When starting a session, power on (1) SC6000 PRIME and other input sources, (2) your mixer, and then (3)
output devices.
• When ending a session, power off (1) output devices, (2) your mixer, and then (3) SC6000 PRIME and
other input sources.
8. To use Engine (standalone playback): Insert a USB flash drive or SD card (with an Engine-configured music
library) to one of SC6000 PRIME’s USB ports or SD Card Slot.
Connection Diagrams
Items shown but not listed under Introduction > Box Contents are sold separately.
Example 1
This example shows 2 SC6000 PRIME units with their Link ports connected to each other directly.
Power outlet
SC6000 PRIME
(rear panel)
Power outlet
SC6000 PRIME
(front panel)
SD card USB drive
USB drive
Denon DJ mixer
(rear panel)
SC6000 PRIME
(rear panel)
To Next Page
