4
ENGLISH
Subwoofer connections (DSW-1312)
Connect this input to the pre-out connector for the subwoofer on the
amplier’s SUBWOOFER PRE OUT using the included audio cable.
SUBWOOFER
PRE OUT
Amplier
Included audio cable
(RCA pin-plug cord)
NOTE
• Do not plug the power cord into an AC power outlet until all
connections have been completed.
• Note that clamping pin-plug cords and power cords together or
running pin-plug cords near the power transformer could result in
humming or noise.
Auto standby function
This subwoofer is automatically set to the standby mode if no signal
is input for 5 to 15 minutes, to save electricity.
The power turns on immediately when a signal is input.
Connecting the power cord
Wait until all connections have been completed before connecting
the power cord.
To household
power outlet
(AC 230 V, 50/60 Hz)
Power cord
NOTE
Insert the AC plug securely. Incomplete connections could cause
noise.
Playback
POWER
LEVEL
Using the subwoofer
1
Set POWER to the “ON” position.
2
Adjust the volume using LEVEL.
1.SYS5.1_E1_ENG_00A.indd 4 2013/03/29 20:01:58
To Next Page
Loading...
Need help?
General
