Denon UTP-250 - Disassembly Procedures; Removing Top Cover and Front Panel

ms D-250
TUNER PRE SECTION
DISASSEMBLY PROCEDURES
(Follow these procedures in reverse order to reassemble.)
1. Removing the top cover and front panel
@ Remove the 6 screws which fasten the top cover.
@ Remove the 2 screws of the bottom side which fasten the front
panel.
@ Front panel
@ Disconnect connectors CB3, CB4, CB6, and CB8 which are
attached to the main unit.
@ Remove the FFC cable, which is connected to the main unit, in
the direction of the arrow.
28