SETTING THE ALARMS
SETTING THE ALARMS
NOTE: The alarms can only be used when powered from the mains AC adapter, not when
battery powered.
You can set two completely separate alarm times (ALARM 1 and ALARM 2) and activate
either or both of them to wake you with a buzzer or radio. You can also pre-set the station
preset and volume settings that the alarms will wake you with.
Checking and changing alarm settings
NOTE: -You must complete all settings before leaving the menu or your changes won't be
saved.
Setting the Alarms
• Switch on the radio (Alarm settings cannot be changed when set to Standby).
• Press the Alarm button once to set Alarm 1 or twice to set Alarm 2.
'Alarm 1 Setup' or 'Alarm 2 setup' will appear on the display.
• Press the Station/Select button to continue with setting the alarm.
'Alarm 7 Wizard' or 'Alarm 2 Wizard' will appear on the display to confirm alarm setting.
The alarm is now set in the sequence shown in the next column. Alarm 1 is shown in this
example.
NOTE: Press the Alarm button at any time to exit alarm setting, leaving the settings
unchanged.
To Next Page
Loading...