Why can't I find a station on my Denver DAB-42?
If you cannot find the desired station on your Denver Radio, it might be due to a weak signal or the station not being available in your area. Try using the manual tune function to find the station.
How to fix a Denver DAB-42 that has no power?
If your Denver Radio has no power, it could be due to the power switch being off. Ensure the power switch is in the ON position. Alternatively, the batteries might be flat. Replace them or use mains power.
Why does my Denver DAB-42 make a burbling noise?
If you hear a burbling noise on some stations with your Denver Radio, it could be due to low battery power. Try replacing the batteries or using mains power. It may also be caused by a weak signal; try repositioning the antenna.
Instructions for connecting to mains power and installing batteries.
How to use standby mode and turn the unit off to conserve power.
Procedure for scanning and finding available DAB+ radio stations.
Guide to saving favorite DAB+ stations for quick access.
How to listen to previously stored DAB+ stations.
Instructions for switching to FM mode and tuning stations.
Steps to reset the radio to its original factory settings.
Solutions for when the radio does not turn on.
Instructions for connecting to mains power and installing batteries.
How to use standby mode and turn the unit off to conserve power.
Procedure for scanning and finding available DAB+ radio stations.
Guide to saving favorite DAB+ stations for quick access.
How to listen to previously stored DAB+ stations.
Instructions for switching to FM mode and tuning stations.
Steps to reset the radio to its original factory settings.
Solutions for when the radio does not turn on.
To Next Page
General
