TROUBLESHOOTING
Problem Reason(s) Solution(s)
No Power The Power switch is set to OFF
Batteries are flat
Set the Power switch to the ON position
Replace the batteries or use mains power
Desired station not
found
Weak signal Station not available in
your area
Use the manual tune function
The display is blank This may occur if the broadcaster
changes the label of a service or
removes a label while tuned.
The unit will try re-tune. If not perform a new
scan
I can hear a burbling
noise on some
stations
Battery power is low weak signal Replace the batteries or use mains power Try
re-positioning the antenna
No sound Volume set to minimum Increase the volume level
To Next Page
Loading...
