Need help?Do you have a question about the Depa DL50-M and is the answer not in the manual?
Section dedicated to identifying and solving pump faults.
Identifies potential hazards associated with the pump's operation.
Specifies who is authorized to operate, service, or repair the pump.
Defines the specific purpose for which the pump is designed.
Prohibits unauthorized modifications to the pump.
Guidelines for qualified personnel performing maintenance and repair.
Crucial safety advice for working with pressurized lines.
Essential checks and considerations before installing the pump.
Guidelines for designing and routing pipelines.
Instructions for connecting the compressed air supply.
Guidance on connecting suction and discharge pipes.
Procedures and warnings for starting the pump.
Emergency procedures to follow in critical situations.
Detailed steps for pump disassembly and reassembly.
Procedures for replacing diaphragms, valve seats, and balls.
Possible causes and remedies for no output from the pump.
Troubleshooting steps for reduced pumping performance.
Diagnosing and fixing issues with pump speed and operation.
Causes and solutions for deformed valve balls.
Troubleshooting leaks at the clamp band.
Reasons and solutions for premature PTFE diaphragm cracking.
Information on equipment for explosive atmospheres.
Specific tightening torque values for Series L pumps.
Specific tightening torque values for Series SF pumps.
Specific tightening torque values for Series M pumps.
Specific tightening torque values for Series PT pumps.
Specific tightening torque values for Series M DH-FA/SA/SS pumps.
Specific tightening torque values for Series P DH-PT/-TL pumps.
Specific tightening torque values for Series P PM pumps.
General| Category | Water Pump |
|---|---|
| Model | DL50-M |
| Frequency | 50Hz |
| Inlet/Outlet Diameter | 1 inch |
| Voltage | 220V |
To Next Page
