EasyManua.ls Logo

Desa 200T - Product Identification; Unpacking; Fuels; Ventilation

Default Icon
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
109891-01B
3
3
For more information, visit www.desatech.com
For more information, visit www.desatech.com
PRODUCT IDENTIFICATION
PRODUCT IDENTIFICATION
UNPACKING
FUELS
VENTILATION
UNPACKING
1. Remove all packing items applied to heater for shipment.
2. Remove all items from carton.
3. Check items for any shipping damage. If heater is damaged,
promptly inform dealer where you bought heater.
Figure 1 - 125T, 170T and 200T Models
FUELS
Use only kerosene, #1/#2 diesel/fuel oil, JET A or JP-8 fuels.
Heavier fuels such as No. 2 fuel oil or No. 2 diesel fuel may also be
used but will result in:
noticeable odor
additional fuel filter maintenance
the need for nontoxic, anti-icer additives in very cold weather
Do not use fuels heavier than No. 2 grade or heavy oils such as oil
drained from crankcases. These heavy oils will not ignite properly
and will contaminate the heater.
IMPORTANT:
Use a KEROSENE ONLY (blue) or DIESEL ONLY
(yellow) storage container. Be sure storage container is clean. Foreign
matter such as rust, dirt, or water will cause the ignition control
assembly to shut down heater. Foreign matter may also require
heater's fuel system to be frequently cleaned.
WARNING: Use only kerosene, #1/#2 diesel/fuel
oil, JET A or JP-8 fuels to avoid risk of re or explo-
sion. Never use gasoline, oil drained from crank-
cases, naphtha, paint thinners, alcohol or other highly
ammable fuels.
VENTILATION
WARNING: Provide a fresh air opening of at least
three square feet (2,800 square cm) for each 100,000
BTU/HR rating. Provide extra fresh air if more heaters
are being used. The minimum ventilation require-
ments must be followed to avoid risks associated
with carbon monoxide poisoning. Make certain these
requirements are met prior to operating heater.
Example:
A 58.6kw (200,000 Btu/Hr) heater requires one of the
following:
a two-car garage door [4.88 meter (16 feet) opening] raised
12.7 cm (5 inches)
a single-car garage door [2.74 meter (9 feet) opening] raised
20.3 cm (8 inches)
two, 76.2 cm (30 inch) windows raised 38.1 cm (15 inches)
Lower
Shell
Hot Air
Outlet
Control
Cover
Fuel Cap/
Gauge
Upper Shell
Ignition Control Assembly
(On Inside of Control Cover)
Fan
Guard
Fuel Tank
Thermostat Knob
ON/OFF
Switch
Shroud
Rear Panel
Handle
Extension
Cord Wrap

Related product manuals