www.desatech.com
113170-01E 7
Ground Lug
Ground Wire (#10 AWG
- Stranded-Copper)
Copper
or Brass
Grounding
Point
Alternator
Figure 6 - Typical Generator Grounding
Method (Generator construction may
vary from that shown)
OPERATION WITH
PORTABLE GENERATOR
WARNING: Before operating
heater or any appliance from a
portable generator, verify that
generator has been properly con-
nected to earth ground. Improper
grounding or failure to ground
generator can result in electro-
cution if a ground fault occurs.
Refer to owner’s manual supplied
by generator manufacturer for
proper grounding procedures.
The operating voltage range of the heater is 108 to
132 Volts (120 Volts +/- 10%). Prior to plugging
heater into generator the output voltage should be
verified (if generator is equipped with the automatic
idle feature, the output voltage should be measured
with the generator running at full speed). If the volt-
age does not measure in this range the heater should
not be plugged into the generator.
Refer to
Operation, page 5, for starting, stopping
and resetting heater procedures.
STORING,
TRANSPORTING OR
SHIPPING
Note: If shipping, transport companies require
fuel tanks to be empty.
1. Remove drain plug from bottom side of fuel
tank and drain all fuel.
2. Replace drain plug.
3. If any debris is noted in old fuel, add 1 or 2
quarts of clean kerosene to tank, stir and drain
again. This will prevent excess debris from
clogging filters during future use.
4. Properly dispose of old and dirty fuel. Check
with local automotive service stations that
recycle oil.
5. If storing, store heater in dry place. Make sure
storage place is free of dust and corrosive
fumes.
IMPORTANT: Do not store kerosene over sum-
mer months for use during next heating season.
Using old fuel could damage heater.
To Next Page
Loading...
Need help?
General
