EasyManua.ls Logo

Desa GA3700T User Manual

Desa GA3700T
4 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Parts included with this kit:
Part No. Description Quantity
Instruction Sheet 1
103581-01 Blower 1
101614-02 Switch and Cover Assembly 1
101398-02 Wire Harness 1
104036-01 Power Cord and Plate Assembly 1
104038-01 Mounting Hardware Kit 1
(includes all parts below)
M11084-26 #10 x 3/8" sheet metal screws 1
M11084-38 #8 x 3/8" sheet metal screws 3
103708-01 #6 x 1/4" sheet metal screws 2
099123-01 Wire Clips 3
099998-01 Fan Switch 1
101584-04 Wiring Diagram Decal 1
101629-01 Plastic Hole Bushing 1
Tools Required
Flat Blade Screwdriver
Phillips Screwdriver
If any of these pieces are missing or damaged, contact the dealer where you purchased this
kit or DESA International at 1-800-972-7879 for referral information.
INSTALLATION INSTRUCTIONS
FOR GA3700T/GA3650T/FA3700T
BLOWER ACCESSORY
DESA INTERNATIONAL
(Check your owners manual for specific applications and additional instructions.)
WARNING: ELECTRICAL GROUNDING INSTRUCTIONS
This appliance is equipped with a three-prong (grounding) plug
for your protection against shock hazard and should be plugged
directly into a properly grounded three-prong receptacle.
Question and Answer IconNeed help?

Do you have a question about the Desa GA3700T and is the answer not in the manual?

Desa GA3700T Specifications

General IconGeneral
BrandDesa
ModelGA3700T
CategoryFireplace Accessories
LanguageEnglish

Summary

Install Blower Accessory in 32" Firebox

Prepare Fireplace for Installation

Remove fireplace screen, logs, and log base assembly before installing blower.

Mount Blower and Power Cord Assembly

Attach blower to firebox rear wall and mount power cord plate to floor support bracket.

Install Switch, Cover, and Selector

Mount thermostatic switch, cover assembly, and selector switch to the firebox.

Connect Wiring and Secure Power

Attach ground wire, connect remaining terminals, secure wires, and plug in power cord.

Test Blower Operation

Verify power cord and wires are clear, then test blower operation using the selector switch.

Operating the Blower

Blower Operation Modes

Understand the ON, OFF, and AUTO settings for the thermostatic blower operation.

Blower Performance Notes

Blower may run independently of gas logs; it distributes heated air effectively.

Limited Warranty

Related product manuals