Detection Systems Abacus User Guide
Chapter 4.19
Programming tips for Version 7000 Software.
1. To delete the last letter, press 0/ESC key or YES/PART key followed by the NO key.
2. To delete the displayed text, press YES/PART key,0/ESC key followed by the NO key.
3. For fast exit, press YES/PART key followed by 0/ESC key then YES/PART key again.
4. When in library press the 0/ESC key to delete the current word displayed.
5. Press the YES/PART key to accept the letter or word
6. Press the YES/PART key twice for a space.
Code Programming
ONLY A MASTER CODE CAN PROGRAM USER CODES.
An Abacus panel, when it leaves the factory has only one user code set, code 1 is always a master code,
factory set to 1234, this code cannot be removed, it can be changed to any number 4 (4, 5 or 6) digits
you require (See System Features chapter 1). Should you attempt to delete code 1, it will revert to the
factory default of 1234.
From the day mode, enter the User master code (1234).
At this display, press the NO key. (XXXXXX = Code holders name if
programmed).
Press the NO key.
On Version 7000 software, this display appears to allow you to return to the
day mode if you have made a mistake.
Press the YES/PART key.
At this display, press the NO key.
At this display, press the 1 key to enter the programming mode.
At this display, press the 1 key to enter the code-programming mode.
On Version 7000 software enter the code number you wish to change
(see system feature chapter 1)
At this display, press the YES/PART key to go to code 2 or press the NO
key to edit (code 1), the = sign changes to >. If the number is not to be
changed press the YES/PART key, to change number press the NO key and
enter the new 4, 5 or 6 digit code required. (See System Features also
Abacus 6 old software code 7 Duress).
Press the YES/PART key, the > will move to either:
For code 2 and above towards code type (Master).
0712 03:46P
System Off
To Next Page
Loading...