18
EN
Operating instructions for the multifunction
watch
Setting the weekday
1. Pull out the crown into the 1st position
2. Set the weekday by turning the crown clockwise
3. Push back the crown into the normal position after the weekday has
been adjusted.
Setting the time
1. Pull out the crown into the 1st position
2. Set the time by turning the crown
3. Push back the crown into the normal position after the time has been
adjusted.
Setting the date
Caution: Do not set the date between 9 pm and half past midnight.
1. Pull out the crown into the 1st position. Set the date by turning the
crown clockwise.
2. Push back the crown into the normal position after the date has been
adjusted.
To Next Page
Loading...
