DETROLA KM837 - Overloading and Object;Liquid Entry; Servicing and Damage Requirements; Replacement Parts and Safety Checks; Mounting and Heat Source Avoidance

15. Overloading - Do not overload wall outlets, extension cords,
or integral convenience receptacles as this can result in a
risk of fire or electric shock.
16. Object and Liquid Entry - Never push objects of any kind
into this product through openings as they may touch
dangerous voltage points or short - out parts that could result
in a fire or electric shock. Never spill liquid of any kind on
the product.
17. Servicing - Do not attempt to service this product yourself
as opening or removing covers may expose you to dangerous
voltage or other hazards. Refer all servicing to qualified
service personnel.
18. Damage Requiring Service - Unplug this product from the
wall outlet and refer servicing to qualified service personnel
under the following conditions;
a. When the power-supply cord or plug is damaged.
b. If liquid has been spilled, or objects have fallen into the
product.
c. If the product has been exposed to rain or water.
d. If the product does not operate normally by following the
operating instructions. Adjust only those controls that are
covered by the operating instructions as an improper
adjustment of other controls may result in damage and
will often require extensive work by a qualified technician
to restore the product to its normal operation.
e. If the product has been dropped or damaged in any way.
f. When the product exhibits a distinct change in performance
- this indicates a need for service.
19. Replacement Parts - When replacement parts are required,
be sure the service technician has used replacement parts
specified by the manufacturer or havethe same characteristics
as the original part. Unauthorized substitutions may result
in fire, electric shock, or other hazards.
20. Safety Check - Upon completion of any service or repairs
to this product, ask the service technician to perform
safety checks to determine that the product is in proper
operating condition.
21. Wall or ceiling Mounting - The product should be mounted
to a wall or ceiling only as recommended by the manufacturer.
22. Heat - The product should be situated away from heat
sources such as radiators. Heat registers, stoves, or other
products(including amplifiers) that produce heat.
WARNING: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
ofthe FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful intereference to radio or television reception,
which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one
or more of the following measures:
- Reorient or relocate the receiving antenna.
- |ncrease the separation between the equipment and receiver.
- Connect the equipment into an circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio TV technician for
help.