EasyManua.ls Logo

Deutronic DBL700 - General Safety Instructions

Default Icon
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Deutronicstr. 5, D - 84166 Adlkofen
Tel.: +49 (0) 8707 920-199
Fax: +49 (0) 8707 1004
E-Mail: sales@deutronic.com
http://www.deutronic.com
4
1) General safety instructions
- The battery charger contains components which are likely to generate electric arcs and sparks, thus the device has
to be placed during operation in a special housing or in a room provided a for this purpose
- Warning: When charging batteries explosive gases may occur. As a fact of that avoid fire, open light and spark
formation
- Only charge batteries in well ventilated places
- The charger might only be utilised for the appointed applications, it is designed for professional applications for motor
vehicle manufacturers and garages
- Depending on the type of charger it is only allowed to contact lead (Pb) batteries with 12 Volt respectively 24 Volt
nominal voltage
- The battery which has to be charged must have a nominal capacity of 1Ah at minimum
- It is not possible and not allowed to charge non rechargeable batteries with this device
- Not on any account it is permitted to charge batteries in operation mode 'POWER SUPPLY'
- Charging of fresh filled or defective batteries is explicitly forbidden
- In any case pay attention to the guidelines of the battery manufacturer!
- Mains cables must always be in a proper state, renew defective cables immediately
- The device mustn’t be opened because as well the test certification as the warranty expires

Related product manuals