Technical Specifications:
Operation:
1. Plug the power cord into a standard 220-240V AC electrical outlet.
2. Press “ON/OFF” button, the product is working on 1200W, the three red lights on.
3. Press “MODE” button to change the Fan mode – Regular Fan(three blue lights), Warm
Fan(one red light), Hot Fan(three red light)
4. Press “TURN” button, the heater will turn automatically with an angle about 70°
5. Press “+” or “-” button, setting the temperature you need
6. Press “MODE” button for 5 seconds, display shows timer, press “+” or “-” button to set
the timer you need to auto power off the heater(up to 9 hours), the display will shinning 5
times to finish the setting.
7. This device has auto tip-over function, it will power off automatically if topple over.
8. This device has thermostat inside, it will stop heating if the heater is over heated, and
will heat again after cooling down.
MAINTENANCE AND STORING
1. Always be sure that the appliance is switched OFF before cleaning or attempting to store
the item. Do not immerse heater in water or allow water to drip into the interior of the
heater, as this could create an electric shock hazard.
2. Allow the product to completely cool before handling or cleaning it.
Ensure the heat select knob is in the shutdown position and the power cord is unplugged
from the electrical outlet before cleaning the product.
STORING
When storing heater during the off season, be sure to store it in dry area. Wrap the power
cord into a neat package. The power cord should not be in contact with sharp edges, and it
should not be compressed by heavy objects. Store the cord in a clean, dry location always
from metal objects. Always check the plug before use to assure metal items haven’t become
attached.
Do not place any heavy items on top of appliance during storage as this may result in
possible damage of appliance.
To Next Page
Loading...
