6
PREPARATION BEFORE USE
A. SETTING UP
B. CONNECTING
C. CLEANING
1. Remove the exterior and interior packaging. Check that the ice basket and ice scoop are included.
If any parts are missing, contact our Customer Service immediately.
2. Clean the ice maker (see Section C below).
3. Find a location to place your ice maker that is away from direct sunlight and other sources of heat
(such as a stove, furnance or radiator). Place the ice maker on a level surface. Make sure that there
is at least 100mm of space around the back and sides of the ice maker with adjacent walls.
44. Allow one hour for the refrigerant fluid to settle before plugging in the unit.
5. The appliance must be positioned so that the plug is easily accessible.
WARNING: Use only potable water for making ice cubes
1. The unit must be properly grounded for your safety. The power cord of this appliance is equipped
with a grounding plug that mates with a standard grounded wall outlet to minimise the possiblity
of an electric shock.
2. Plug in the appliance into an exclusive and properly installed grounded wall outlet. Do not under any
circumstances damage the grounding means of the plug. Any questions concerning power and/or
grounding should be directed to a certified electrician.
33. This appliance requires a standard 220-240V, 50Hz electrical supply with good grounding means.
Before using the ice maker, it is strongly recommended that the ice maker is cleaned thoroughly.
1. Remove the ice cube basket.
2. Clean the interior with diluted detergent, warm water and a soft cloth.
3. Then use the solution to rinse the inner parts and drain out the solution by unplugging the water
drainage plug at the side of the ice maker.
4. Clean the exterior of the ice maker regularly with a mild detergent solution and warm water.
55. Dry the interior and exterior with a soft cloth.
6. When the appliance is not in use for a long time, drain the water completely from the ice maker
by opening the water drainage plug.
DANGER: Improper use of the grounded plug may result in the risk of electric shock.
If the power cord is damaged, please contact our Customer Service immediately.
To Next Page
Loading...
