7
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
1. Open the cover of the water reservoir and pour potable water into the water reservoir. Be sure to
keep the water below the maximum level at the FULL mark shown in the drawing below. Replace
the cove immediately to prevent any foreign matter from contaminating the water.
2. Plug the unit into the wall outlet. Press the ON/OFF button on the control panel to turn on the unit to
begin the ice cube making process.
3. When the unit is plugged in, the symbol will flash. Press the ON/OFF button on the
display and the unit will start making ice cubes. The symbol will always be on display and the
symbol will also be constantly on.
4. The top of the display will show the ambient temperature and duration of the ice cube making
process. The flashing numbers on the right side of the ambient temperature display shows the end
of the ice making process. The numbers on the lower right of the display is the settings for the ice
cube making duration. The default is ‘0’.
WARNING: Do not pour water into the internal water tank located underneath the ice cubes
basket. This tank is not large enough and will affect the ice cube making process.
NOTE: The ice cube making cycle last about 15 to 25 minutes depending on the ambient temperature.
When making ice cubes for the first time, depending on the initial water temperature, the ice cube
making duration will be a little bit longer. In an extremely hot environment, the ice cube making duration
may vary extensively but will not exceed 40 minutes.
To Next Page
Loading...
