8
OPERATING INSTRUCTIONS
5. To adjust the thickness of the ice cubes, press ‘+’ or ‘-’ on the control panel. For thicker ice cubes,
press ‘+’ to prolong the processing time. Press once to add a minute longer. The maximum time
to extend the processing time is 6 minutes. Once the appliance is restarted, it will reset to ‘0’.
TIP: Press ‘+’ and ‘-’ simultaneously for more than 5 seconds and the LCD display blue light will come
on. It can be used as a night light. Press again to switch off the light.
6. Each time the ice cube making process is completed, the symbol will flash. The water in the
water reservoir will automatically fill up the inner water tank. Throughout this process, the symbol
will flash until the water in the inner water tank has reached its maximum water level.
7. When the water reservoir is out of water, the inner water tank cannot be filled and the symbol
will stay on. The appliance will also stop working. After filling water into the water reservoir, restart
the appliance or wait for 20 minutes for an automatic restart.
88. The ice cube making process will automatically stop when the ice cubes basket is full and the
symbol will light up in the LCD display.
9. Change the water in the water reservoir every 24 hours to ensure a reasonable hygiene level. If the
unit is not used for a long time, drain all water inside the inner water tank and water reservoir.
10. To drain the water, remove the water drainage plug at the back of the unit.
Take out the silicon plug and drain away the water inside. It is recommended
to change the water every day and clean the unit every 3 days.
WARNING
A. Make sure that the water reservoir, water filter and water separator pipe are not blocked. Clean
them regularly.
B. The water temperature will affect the ice cube making capacity. A lower water temperature will
produce more ice cubes.
C. A cooler ambient temperature will also help the unit to produce more ice cubes.
DD. Always use good quality water to ensure that the pump will work well. Poor quality water will
produce some pump noise but it will not affect the unit operations.
E. The compressor will restart in 3 minutes after you have turned off the unit.
NOTE
· Check to ensure the water filter located at the bottom of the large water reservoir and inner water
tank are not obstructed by any dirt or foreign matter.
· Always fill up water in the large water reservoir to the maximum water level.
· After moving or shifting the unit, allow the refrigerant inside the compressor to settle for at least
3 minutes before restarting.
To Next Page
Loading...
