DeVilbiss Air Power Company EXHA2425-WK User Manual (English)

Questions and Answers:

N
nathan46Aug 5, 2025
How to troubleshoot starting issues in DeVilbiss Air Power Company EXHA2425-WK?
- L
  Logan WhiteheadAug 5, 2025
  To troubleshoot why your DeVilbiss Air Power Company Pressure Washer engine won't start, consider these potential causes: * **No fuel:** Add fuel. * **Low oil:** Add the required amount of oil if your model has a low oil shutdown feature. * **Pressure build-up:** Squeeze the gun trigger to relieve pressure. * **Priming/Choking Issues:** Push the primer bulb 3 times or choke the engine. * **Spark Plug Wire:** Attach the spark plug wire. * **Engine ON/OFF Switch:** Ensure the engine ON/OFF switch is in the ON position. * **Choke lever position:** Move the choke to the “No Choke” position if the engine is hot. * **Fuel valve position:** Move the fuel valve lever to the “Open” position if your equipment is equipped with one.
J
jburnsAug 15, 2025
Why does my DeVilbiss Air Power Company EXHA2425-WK have low pressure after normal use?
- R
  Roger HensleyAug 15, 2025
  If your DeVilbiss Air Power Company Pressure Washer has no or low pressure after a period of normal use, it could be due to: * **Worn seal or packing:** Have it replaced by an AWSC. * **Worn or obstructed valves:** Have them replaced by an AWSC. * **Worn unloader piston:** Have it replaced by an AWSC. * **Worn E-Z start valve:** Have it replaced by an AWSC.
R
robin71Aug 19, 2025
What to do if DeVilbiss Air Power Company EXHA2425-WK Pressure Washer will not draw chemicals?
- D
  Dennis LopezAug 20, 2025
  If your DeVilbiss Air Power Company Pressure Washer won't draw chemicals, consider these possible causes: * **Wand setting:** Refer to the 'How to Use Wand' paragraph in the Operation Section. * **Chemical filter:** Clean the chemical filter. * **Chemical screen:** Ensure the end of the chemical hose is fully submerged in the chemical. * **Chemical thickness:** Dilute the chemical if it is too thick. * **Pressure hose length:** Lengthen the water supply hose instead of the pressure hose. * **Chemical build-up:** Have the parts cleaned or replaced by an AWSC.