2 © 2015 Finishing Brands UK Ltd.
EC Declaration of Conformity
We, Finishing Brands UK Limited, Ringwood Rd, Bournemouth, Dorset, BH11 9LH, UK, as
the manufacturer of the Automatic Spray gun model AGN, declare, under our sole responsibility,
that the equipment to which this document relates is in conformity with the following standards or
other normative documents:
BS EN ISO 12100: 2010, BS EN 1953:2013; and thereby conform to the protection
requirements of Council Directive 93/37/EC relating to Machinery Safety Directive.
This product also complies with the requirements of the EPA guidelines, PG6/34. Transfer
efficiency certificates are available on request.
D. Smith, General Manager
18
th
December 2014
Finishing Brands UK Limited reserves the right to modify equipment specification without prior notice.
AGN-502 Spray gun fitted with fan air control valve.
For ordering information see chart 1 for the selection of air cap and nozzle combinations. Add thread code for the hose
connection thread required.
Important
Read and follow all instructions and Safety Precautions before using this
equipment
Operational Description
This AGN-502 Is a lightweight diaphragm operated automatic spray gun for use with ceramic glaze,
vitreous enamels, liquid polishing compounds and similar materials. The standard gun fitted with a
rubber diaphragm is not suitable for use with solvent based coating materials; however it can be
converted for use with solvent based coating materials by fitting a PTFE protective diaphragm see
Accessories. Nozzles are available in high grade stainless steel and case hardened Nitralloy steel.
Remotely positioned valves (supplied by user) control the air supplies for atomisation and
diaphragm operation. Coating material supply is by a pressure feed system.
IMPORTANT: These guns are not designed for use with highly corrosive or highly abrasive coating
material and if used with such materials it must be expected that the need for thorough cleaning
and/or the necessity for replacement parts will be increased. If there is any doubt regarding the
suitability of a specific material, advise what material is to be used and/or submit a sample for test.
To Next Page
Loading...
