8- ENG
D24152
Operation
Before each use:
l
Drain water from air
compressor tank and con-
densation from air lines.
See air compressor’s
operators manual.
Disconnect the ratchet
wrench from the air supply
before lubricating or
changing sockets.
l
Lubricate tool, see
“Maintenance” section in
this manual.
Impact wrench sockets and accessories must
be used with this tool. Do not use hand
sockets and accessories.
l
Select the required impact socket. This tool has a 3/8" square drive, use
3/8” deep sockets. Use 3/8” extensions only when needed.
Connect tool to air hose of recommended size. NOTE: The use of a quick
connect set makes connecting easier.
IMPORTANT: The use of air filters and air line lubricators is
recommended.
3/8” Air Ratchet
Free Speed @ 90 PSI 150 RPM
(Forward/Reverse)
Maximum Working Pressure 90 PSI
Air Inlet 1/4" NPT
Recommended Hose Size 3/8" I.D.
Maximum Torque 45 Ft./Lbs.
SPECIFICATIONS
ASSEMBLY
Accessories Required
IMPORTANT: Line pressure or hose inside diameter should be increased to
compensate for unusually long air hoses (over 25 feet). Minimum hose diameter
should be 3/8” I.D. and fittings should have 1/4” NPT thread.
OPERATION
Air Inlet
Throttle Control Lever
Reverse/Forward Button
To Next Page
Loading...