Technical specifications
- Self-powered PA speaker kit with one powered speaker, microphone, speaker stand and cables
- built-in power amplifier
- built-in MP3 player with Bluetooth connectivity, SD card and USB drive support
- lightweight construction
- wide projection dispersion horn for optimal wide audio coverage
- built-in audio mixer, for microphones and line-level audio sources
- line output for speaker daisy-chaining
- elegant moulded housing with rounded edges for a clean look
- 3 built-in carrying handles - 2 side handles and 1 top handle
- 35 mm stand adapter with tightening knob, for easy placement on a speaker stand
- handles with integrated monitor stands - no separate stands needed!
Mixing panel features:
- microphone input: 6.35 mm TRS jack or balanced XLR
- line input: 3.5 mm TRS mini-jack, stereo RCA or balanced XLR
- XLR balanced mix output for another speaker (dual mono mode)
- 2-band EQ (High / Low)
- volume control for audio inputs + MP3 player
- Power LED indicator
- Clip LED indicator
Technical details:
- 15 inch woofer, 50oz, 2 inch voice coil, 4 Ohms
- 1 inch tweeter, titanium diaphragm driver, 8 Ohm
- frequency response: 20 Hz – 20 kHz
- nominal speaker impedance: 4 Ohms
- max. SPL: 115 dB (+/- 3 dB)
- sensitivity: 98 dB (+/- 3 dB)
- total weight: 18 kgs
- packing dimensions: 485 x 400 x 735
Power requirements:
- IEC power input with integrated fuse holder
- Power supply: 220 – 240V AC, 50/60 Hz
- Fuse: F2.5AL 250V, 20 mm glass
- power factor: 0.85
- power consumption: 300 W max
Included accessories:
- wired dynamic microphone with XLR connection
- IR remote control
- XLR male – XLR female microphone cable
- foldable speaker stand
- power cable IEC C13 to Schuko
- power cable IEC C13 to UK
Any information and illustrations shown in this user manual are subject to change without further notice.
User manual version: 1.0 Creation date + author initials: 17-06-2015 RV Revision date + author initials:
To Previous Page
Loading...
