Specifications
General specifications for all models:
– robust subwoofer in strong plywood housing
– available in 12, 15 and 18 inches
– metal grille
– acoustic foam behind grille to prevent any unwanted matter from getting inside the speaker
– grille covers the front of the subwoofer for optimal protection
– high-quality finish with black scratch-resistant finish
– rubber feet
– filtered and unfiltered line outputs
– M20 pole mount
– 45 Hz boost button for even more prominent bass reproduction when required
– built-in clip limiter
– Power LED indicator and Clip LED indicator
– 2-band tone control (Bass / Treble)
– IEC C14 power input with fuse holder
– on/off switch
Mixer connectors:
– mini TRS jack line input
– 3-pin XLR or jack plug balanced input, switchable between line and mic signal
– 3-pin XLR or stereo RCA input (mono summing) line input
– 3-pin XLR line output (master line out)
Technical specifications per model:
Model Onyx 12SA Onyx 15SA Onyx 18SA
Frequency range 40 Hz – 150 Hz 35 Hz – 150 Hz 30 Hz – 150 Hz
Amplifier power (RMS /
Peak)
450 W / 1800 W 600 W / 2400 W 600 W / 2400 W
Amplifier type Class D
maximum SPL 120 dB 126 dB 136 dB
Low tone speaker 12-inch woofer with 3-
inch voice coil
15-inch woofer with 4-
inch voice coil
18-inch subwoofer with 4-
inch voice coil
Connection voltage 110 – 230 V AC, 50/60 Hz
Fuse T5.0 AL 250V
Nominal maximum power
consumption
720 W
Dimensions 495 x 590 x 540 mm 530 x 700 x 625 mm 610 x 745 x 680 mm
Weight per speaker 23.5 kg 32.5 kg 38.75 kg
The information in this user manual is subject to change at any time without notice.
Version: 1.0 Date of creation and author's initials: 23-09-2017 RV Revision date and author's initials: -
To Previous Page
Loading...
