DEVOLA DVPH20BEP - Product Specifications; Installation Guide; Clearances and Mounting

• Do not use the heater where gasoline, paint, flammable liquids, or flammable dust are
stored.
• If the heater is used in the bathroom, please be careful to ensure that the heater switch
or controller does encounter the user of the bathtub or shower at any time.
• Do not install the heater in a location where it may fall into a bathtub or other water
container.
• Care should be taken when leaving the heater running and unattended.
• Do not leave the heater running while sleeping.
• Do not insert anything into the heater.
• Do not touch the heater while in use.
• Before adjusting the heater, position or working on it, be sure to always disconnect the
heater from the power supply and allow it to cool.
Product specifications
Model
DVPH1200B /DVPH12BEP
DVPH2000B /DVPH20BEP
DVPH2400B/DVPH24BEP
Voltage
220-240VAC
220-240VAC
220-240VAC
Current
5.2A
8.7A
10.4A
Power
1200W
2000W
2400W
Product size
770 x 160 x 80 mm
870 x 160 x 80 mm
970 x 160 x 80 mm
Installation
Clearances:
During installation, please ensure that the heater is a minimum of 1.8 metres above the ground
so that it cannot be directly touched during operation.
Make sure that the heater is always at least 0.5m wide from the ceiling and adjacent walls.
• This heater must be installed by a qualified electrician.
• Before and during installation, always ensure that the heater is disconnected from the
power supply and is cool.
• The heater can be installed horizontally or vertically.
• When installing horizontally or to a ceiling, do not place the heater at an angle of more
than 90 degrees, or below 45 degrees.
• If the heater installation angle is vertical or close to vertical, make sure the power cord is
always under the heater.
• During the use of the heater, there is a certain increase in the temperature of the heater
body. Make sure that the power cord never touches the heater body and is away from
the heater housing
• Do not install heaters on the surface of any flammable materials.
• If you are using the heater outdoors be sure to use a weatherproof qualified outlet.
• Make sure that there are no wires or water pipes in the area where the heater is going to
be installed before you begin drilling.
• The heater must be installed on the mounting bracket provided by the manufacturer
(see Figure A below).