Heater Control Panel
• First start by turning the heater on. The heater will start in standby mode, displaying the
Wi-Fi icon and the current room temperature in °C.
• Press the ON/OFF button to initiate heating. When the heater is switched on the
heating icon and the Eco mode icon will illuminate by default. This means that the
heater is operating in Eco mode.
• Use the Up and Down buttons to cycle between the heating modes: Eco ,
Comfort and Anti-frost mode . The mode icons will flash as you cycle through
them. After a few seconds, the mode icon will stop flashing and the heater will heat in that
mode.
• To adjust the set temperature of any of the modes you can press the Setting button ,
wait for the light to flash then use the Up and Down buttons to adjust the
temperature. The temperature range is from 5-50°C.
• To set the timer, press the Setting button , when the Timer icon flashes use the
Up and Down buttons to adjust the time. The timer range is 1-24 hours. The digits
will flash while setting and then the screen will return to heating mode. The Timer icon
will not appear on the display to indicate that a timer has been set and the heater will
continue to operate until the selected time has elapsed.
• To set the child lock function press and hold the Up button. The padlock icon will
appear on the display screen and the control panel will now be locked. To disable the child
lock press and hold the Down button. The padlock icon will disappear to indicate
that the child lock function is now inactive, and all buttons can be used again.
• To switch off the display light whilst the heater is in operation press and hold the for
5 seconds. Press the button again to switch the display light back on.
Eco Mode – In this mode the heater works at half of its maximum capacity. For example, if the
heaters full capacity is 2000W, in eco mode it would operate at 1000W.
Comfort Mode – When the heater is operating in comfort mode it is running at its full capacity,
thus, if it is a 2000W heater it will operate at 2000W.
Anti-frost Mode– This mode is specifically designed to prevent frosting. When the ambient
temperature is below 5℃ the product will begin to operate. If the ambient temperature rises greater
than 7℃ the product will automatically cease heating.
Remote Control – The remote-control use distance is 2M. All control panel functions are the same
as the remote control.
To Next Page
Loading...