Press the swing button to turn the louver oscillation
function on or off.
Press the time set button and use the up and down select
buttons to cycle between the days of the week until you
reach the current day. Press the time select button again to
store the current day. Press the time select button for a
further time to set the current hour of the day. Press the
time select button to store the hour and you will be
promoted to set the minutes. To store the above data, you
can press the time set button once more or alternatively
wait three seconds and the unit will automatically save.
Ensure you are in day timer mode using the M/A button.
Press the timer set button and you will be prompted to set
the hour that you want the unit to switch off using the up
and down select buttons. Press the timer set button again
to store the hour and use the up and down select buttons
again to set the shutdown time minute. You are only able to
set a shutdown time within 24 hours in day timer mode. If
the time is currently 20:00 on Monday and you select a
shutdown time of 19:00 the heater will shut down at 19:00
on Tuesday.
Ensure you are in weekly timer mode using the M/A button.
Press the timer set button and use the up and down select
buttons to cycle between the days of the week until you
reach the desired day. Press the timer set button again to
set a start-up hour for heating segment 1. Press the timer
set button to select a shutdown time for heating segment
1. Please note you can only set start up and shutdown
timers in 1-hour increments; minutes cannot be set. You can
set up to four heating segments each day. There will be a 1,
2, 3 or 4 on the display to indicate which heating segment
you are currently setting. If you would like to set less than 4
segments per day continue pressing the timer set button
until you reach the end of the cycle at segment four. You can
amend heating segment start up and shutdown times by
repeating the above process.
Press the M/A button to switch between the day and weekly
timer.
To Next Page
Loading...
