Getting Started (Cont.)
To take the heater off the wall, pull the heater upwards about 5mm and then to the left about
10mm before gently pulling it away from the mounting screws and off the wall.
Operating Instructions
Using the heater
Use the power button to turn the heater on or off.
Use the up and down select button to cycle between the
fan, half power (1000W), and full power (2000W) heating
mode.
Press the temperature set button followed by the up or
down arrows to select desired temperature. Environment
temperature range: 5-45 ℃.
Hold the up and down select buttons at the same time for
five seconds to switch the child lock function On or Off.
Hold the temperature set button for five seconds to delete
the day and week timer.
Use the power button to turn the heater on or off.
Use the up and down select button to cycle between the
fan, half power (1000W), and full power (2000W) heating
mode.
Press the temperature set button followed by the up or
down arrows to select desired temperature. Environment
temperature range: 5-45 ℃.
This heater MUST be installed to the
minimum required distances at the four
sides of the heater.
WARNING!
Do not connect the heater to the power supply until
it is securely mounted
to the wall or until the stands are securely fitted.
Correct installation is required for safe and reliable operation
To Next Page
Loading...
